Provide Fortinet FCSS_EFW_AD-7.4 Practice Test Engine for Preparation
Detailed New FCSS_EFW_AD-7.4 Exam Questions for Concept Clearance
NEW QUESTION # 112
Which statement about IKE and IKE NAT-T is true?
- A. IKE is the standard implementation for IKEv1 and IKE NAT-T is an extension added in IKEv2.
- B. They both use UDP as their transport protocol and the port number is configurable.
- C. IKE is used to encapsulate ESP traffic in some situations, and IKE NAT-T is used only when the local FortiGate is using NAT on the IPsec interface.
- D. They each use their own IP protocol number.
Answer: B
NEW QUESTION # 113
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
Why didn't the tunnel come up?
- A. The remote gateway's phase 2 configuration does not match the local gateway's phase 2 configuration.
- B. The remote gateway's phase 1 configuration does not match the local gateway's phase 1 configuration.
- C. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.
- D. The pre-shared keys do not match.
Answer: B
NEW QUESTION # 114
What is an OSPF area border router?
- A. A router with all its interfaces in the backbone area.
- B. A router that is redistributing connected subnets into the OSPF network.
- C. A router that is redistributing non-OSPF routes into the OSPF network.
- D. A router with interfaces in multiple OSPF areas.
Answer: D
NEW QUESTION # 115
Examine the partial output from two web filter debug commands; then answer the question below:
Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?
- A. General organization.
- B. Finance and banking
- C. Business.
- D. Information technology.
Answer: D
NEW QUESTION # 116
Refer to the exhibit, which contains the debug output of diagnose dvm device list.
Which two statements about the output shown in the exhibit are correct? (Choose two.)
- A. The policy package has been modified for Local-FortiGate.
- B. There are pending device-level changes yet to be installed on Local-FortiGate.
- C. ADOMs are disabled on the FortiManager
- D. The FortiGate configuration is in sync with latest running revision history.
Answer: B,D
NEW QUESTION # 117
When a FortiLink interface is configured on a FortiGate, which VLAN is typically set as the default allowed VLAN on all connected FortiSwitch ports?
- A. Management VLAN
- B. Sniffer VLAN
- C. Camera VLAN
- D. Quarantine VLAN
Answer: A
NEW QUESTION # 118
An administrator added the following Ipsec VPN to a FortiGate configuration:
configvpn ipsec phasel -interface
edit "RemoteSite"
set type dynamic
set interface "portl"
set mode main
set psksecret ENC LCVkCiK2E2PhVUzZe
next
end
config vpn ipsec phase2-interface
edit "RemoteSite"
set phasel name "RemoteSite"
set proposal 3des-sha256
next
end
However, the phase 1 negotiation is failing. The administrator executed the IKF real time debug while attempting the Ipsec connection.
The output is shown in the exhibit.
What is causing the IPsec problem in the phase 1?
- A. The incoming IPsec connection is matching the wrong VPN configuration
- B. The phrase-1 mode must be changed to aggressive
- C. The pre-shared key is wrong
- D. NAT-T settings do not match
Answer: C
NEW QUESTION # 119
View the IPS exit log, and then answer the question below.
What is the status of IPS on this FortiGate?
- A. All IPS-related features have been disabled in FortiGate's configuration.
- B. IPS engine memory consumption has exceeded the model-specific predefined value.
- C. There are communication problems between the IPS engine and the management database.
- D. IPS daemon experienced a crash.
Answer: A
NEW QUESTION # 120
Refer to the exhibit, which contains a partial routing table.
Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route?
(Choose two.)
- A. Source IP address 10.1.0.24, Destination IP address 10.72.3.20.
- B. Source IP address 10.72.3.27, Destination IP address 10.1.0.52.
- C. Source IP address 10.72.3.52, Destination IP address 10.1.0.254.
- D. Source IP address 10.73.9.10, Destination IP address 10.72.3.15.
Answer: B,C
NEW QUESTION # 121
Which statement about administrative domains (ADOMs) on FortiManager is true?
- A. FortiGate devices with multiple VDOMs must be assigned to the same ADOM on FortiManager.
- B. The ADOM feature can be enabled by any administrative user.
- C. The number of configurable ADOMs is based on the FortiManager FortiCare service contract.
- D. ADOMs allow grouping of managed devices based on management criteria and administrative access.
Answer: D
NEW QUESTION # 122
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. BGP peer 10.200.3.1 has never been down since the BGP counters were cleared.
- B. Local BGP peer has not received an OpenConfirm from 10.200.3.1.
- C. BGP state of the peer 10.125.0.60 is Established.
- D. The local BGP peer has received a total of 3 BGP prefixes.
Answer: B,C
NEW QUESTION # 123
In which two ways does FortiManager function when it is deployed as a local FDS? (Choose two.)
- A. It supports rating requests from non-FortiGate devices.
- B. It can be configured as an update server, a rating server, or both.
- C. It caches available firmware updates for unmanaged devices.
- D. It provides VM license validation services.
Answer: B,D
NEW QUESTION # 124
Which of the following statements are correct regarding application layer test commands? (Choose two.)
- A. They are used to filter real-time debugs.
- B. Some of them can be used to restart an application.
- C. They display real-time application debugs.
- D. Some of them display statistics and configuration information about a feature or process.
Answer: B,D
NEW QUESTION # 125
A FortiGate's port1 is connected to a private network. Its port2 is connected to the Internet. Explicit web proxy is enabled in port1 and only explicit web proxy users can access the Internet. Web cache is NOT enabled. An internal web proxy user is downloading a file from the Internet via HTTP.
Which statements are true regarding the two entries in the FortiGate session table related with this traffic? (Choose two.)
- A. Both session have the local flag on.
- B. The destination IP addresses of both sessions are IP addresses assigned to FortiGate's interfaces.
- C. One session has the proxy flag on, the other one does not.
- D. One of the sessions has the IP address of port2 as the source IP address.
Answer: A,D
NEW QUESTION # 126
Refer to the exhibit, which shows the output of get system ha status. NGFW-1 and NGFW-2 have been up for a week.
Which two statements about the output are true? (Choose two.)
- A. If FGVM...649 is rebooted, FGVM...650 will become the primary and retain that role, even after FGVM...649 rejoins the cluster.
- B. If no action is taken, the primary FortiGate will leave the cluster due to the current sync status.
- C. If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.
- D. If port7 becomes disconnected on the secondary, both FortiGate devices will elect itself the primary.
Answer: A,D
NEW QUESTION # 127
What is the primary function of segmentation in network management?
- A. To enhance the decryption and encryption speeds within the network
- B. To encrypt data traffic across the network
- C. To divide a network into smaller, isolated segments for enhanced security
- D. To connect multiple physical switches in a single logical interface
Answer: C
NEW QUESTION # 128
......
FCSS_EFW_AD-7.4 2025 Training With 212 QA's: https://www.examprepaway.com/Fortinet/braindumps.FCSS_EFW_AD-7.4.ete.file.html
FCSS_EFW_AD-7.4 Exam Preparation Material with New FCSS_EFW_AD-7.4 Dumps Questions.: https://drive.google.com/open?id=1vqYb4wnRm2GroXxKwa-JE1K5lQ7btYgH